Industrially Selected Polyacrylamide PAM Anionic Sand Washing Mud Sewage Treatment Flocculant
Price:
USD1500-2500
MOQ:
1 MT
Delivery Time:
7-`5 WORKING DAYS
Brand:
OYI POLYMER
Product Description
A765 Industrially Selected Polyacrylamide PAM Anionic Sand Washing Mud Sewage Treatment Flocculant
Flocculation Effect
- Rapid flocculation, tight flocs but small dosage.
- Highly clear treated water.
- PH value has a wide range of application.
- Excellent filtration and dewatering properties improve the sludge dewatering results.
- Good compatibility with inorganic coagulants.
OYIFLOC Cationic Polyacrylamide Specifications
| Appearance | White Powder |
| Mass fraction of polymer content | ≥89% |
| Charge degree: | 10-30% |
| Molecular weight | 12-18 million |
| Mass fraction of acrylamide monomer | ≤0.25% |
| Dissolving time (1g/L) | ≤60min |
Main Applications
- Tailings Thickening* Faster settling rates* Higher underflow solids concentration* Reduced thickener footprint
Clarification & Water Recovery
* Clear overflow water suitable for reuse* Reduced freshwater intake* Improved process water recyclingSludge Dewatering* Enhanced performance in thickeners and settling ponds* Reduced sludge volume* Lower disposal and handling costsMining & Metallurgy Processes* Copper, gold, iron ore, coal, bauxite, phosphate, lithium, and other mineral tailings* Compatible with most thickener and clarifier designs
Product Advantages
- Economical and achieve good effects at low dosage.
- Significantly improve the sludge production efficiency and reduce the moisture content of sludge cake
- lncrease the settling rate of suspended solids during the solid-liquid separation in sewage treatment process.
- Highly effective in a wide PH range(2-9), it is capable of treating waste water and sludge under weak acidic condition.
Product Forms
Anionic Polymer Flocculant Powder | Anionic Polymer Flocculant Emulsion |
|
|
|
|
Usage Instructions
Preparation:
Dissolve CPAM in clean water to make a 0.1%–0.3% aqueous solution. Stir slowly to avoid clumping.
Application:
Add the prepared solution evenly into the wastewater system.
Dosage:
Typical dosage is 1–10 ppm, depending on wastewater characteristics.
Mixing:
Allow proper mixing and reaction time for optimal floc formation.
How to use OYIFLOC Anionic Polymer Flocculant?
- Prepare stock solution if using powder: dissolve 0.1-0.2 g/L in water (adjust per lab test). Stir for 30–60 minutes until fully hydrated.
- Liquid product: dilute to recommended working concentration per technical sheet.
- Typical dosage range: 0.1–10 mg/L (vary by application and water quality). Perform jar test to determine optimal dose.
- Add flocculant after coagulation stage or directly to influent stream; mix gently then allow settling. Adjust pH and dose based on jar test results.
Similar Products
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.
Company
WUXI OYI ENVIRONMENTAL TECHNOLOGY CO LTD
Location
NO.01, YIXING ECONOMIC DEVELOPMENT ZONE, JIANGSU, CHINA, 214200
Contact Person
Doris