slide potentiometer CTR C2043N-CE10B5.0-W503-0P0 featuring 50K resistance and mechanical stability
Price:
Negotiable
MOQ:
Negotiable
Delivery Time:
Negotiable
Product Description
Product Overview
The C2043N is a slide potentiometer designed for consumer products, offering precise control with a nominal total resistance of 50K 20%. It operates within a wide temperature range and features reliable electrical and mechanical characteristics for consistent performance.
Product Attributes
- Model: C2043N
- Type: Slide Potentiometer
- Origin: Dongguan Changtaier Electronics Co., Ltd.
Technical Specifications
| Item | Conditions | Specifications |
|---|---|---|
| 1 GENERAL | ||
| Scope | Model C2043N type, mainly used for consumer products | |
| Operating temperature range | -10~60 | |
| Storage temperature range | -10~70 | |
| Test conditions | Standard atmospheric conditions: Ambient temperature:5~35 Relative humidity:45~85% Air pressure:86~106kpa Reference conditions: Ambient temperature:202 Relative humidity:60~70% Air pressure:86~106kpa | |
| 2 ELECTRICAL CHARACTERISTICS | ||
| Nominal total resistance and tolerance | Resistance between terminals 1 and 3 | 50K20% |
| Resistance law | W Taper (Refer to the attached) | |
| Power rating | Max continuous full load operation at max voltage between terminals 1 and 3. (Graph for power rating vs. ambient temperature denoted) | 0.2W |
| Rated voltage | E = PR/R; P: Rated power, R: Nominal total resistance | 200V AC (Max Operation Voltage 10V DC) |
| Residual resistance | R1,2; R2,3 | 20; 30 |
| Slide noise | Apply DC 20V between terminals 1-3 (rated voltage 20V, apply by rated voltage) | 68mVp-p |
| Insulation resistance | Apply voltage of DC 500V between individual terminals and frame for 1 minute. | 50M |
| Dielectric strength | Between individual terminals and frame | 500V AC for 1 minute. (Trip current: 2mA) |
| 3 Mechanical characteristics | ||
| Total travel slide | Effective slide travel | 200.5mm |
| Sliding force | Standard atmospheric conditions, Sliding speed: 1 Cycles/3s | 10~80gf |
| Number of Detents | Without Detent, 1C (Center Detent), Other | |
| Click slip out | Standard atmospheric conditions, Sliding speed: 20mm/sec | 20~110gf |
| Stop strength | Torsion moment load of 3Kgf.cm applied to the shaft for 5sec at both ends (after fixation) | Electrical characteristics shall be satisfied. |
| Lever wobble | Without damage such as bad sliding and braking or play in the lever. | |
| Thrust and tensile lever | Static load of 5kgf.cm applied to the lever in the lever directions for 10 sec. | Electrical characteristics shall be satisfied. |
| Terminal strength | 0.5kgf static force applied along the terminal position for 10 sec (after fixation) | Electrical characteristics shall be satisfied. |
| 4 ENDURANCE CHARACTERISTICS | ||
| Solder ability | Terminals immersed into solder bath at 2605C for 30.5s. 75% minimum of surface covered. | |
| Resistance to heat (soldering) | Preheating: Substrate surface temperature within 100C in one minute. Wave soldering: Bit temperature 3505C, Application time 5 1 sec. | Change in total resistance: 5%. No case deformation or terminal loosening. Electrical characteristics satisfied. |
| Resistance to heat | 1208h in a thermostatic chamber at 702C. Measured after maintaining at standard atmospheric conditions for 1h. | Change in total resistance: 20%. |
| Resistance to cold | 1204h in a thermostatic chamber at -253C. Measured after removing surface moisture and maintaining at standard atmospheric conditions for 1h. | Change in total resistance: 20%. |
| Damp heat | 1204h in a thermostatic chamber at 402C, 90% to 95% RH. Measured after removing surface moisture and maintaining at standard atmospheric conditions for 1h. | Change in total resistance: +35%~-5%. Insulation resistance: 50M. Noise: 150mV p-p. |
| Change of temperature | 5 successive temperature cycles. Measured after removing surface moisture and maintaining at standard atmospheric conditions for 1h. | Change in total resistance: 30%. Insulation resistance: 100M. Dielectric strength: Without damage, arcing or breakdown. |
| Endurance | Moving contact rotated from one end stop to the other and returned to original position (effective angle >90%). 600 cycles/hour. Total 10000200 cycles. | Change in total resistance: specified value15%. Rotational noise: 150mVp-p. Rotational torque shall not deviate from previously specified value. Residual resistance R1~2: 40, R2~3: 60. |
Similar Products
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.
Company
Beijing Silk Road Enterprise Management Services Co., Ltd.
Location
16 Floor, Unit B, Jiatai International Mansion, No 41, Dongsihuan Zhong Road, Chaoyang District, Beijing
Contact Person
Sellina