Electronic control rotary potentiometer 10mm G-Switch RA1010N-1H-2016-B50K-000 with precise rotation

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

10mm ROTARY POTENTIOMETER

A 10mm rotary potentiometer designed for various electronic applications. This component offers precise control over resistance and is built to withstand specific environmental and mechanical conditions.

Product Attributes

Brand: G-Switch Electronics Science and technology Co.,Ltd
Part Name: RA1010N
Origin: (Dongguan, China)

Technical Specifications

Category	Item	Specifications	Description
Environment	Operating temperature range	-10+70C
	Storage temperature range	-25+75C
	Test conditions (Standard)	Ambient temperature: 535C Relative humidity: 4585% Air pressure: 8601060mbar	()
	Test conditions (Reference)	Ambient temperature: 202C Relative humidity: 6070% Air pressure: 8601060mbar	()
	Test conditions (Reference)
Mechanical Characteristics	Total rotational angle	27010
	Rotational torque	10~70gf.cm
	Rotational speed	60/1 sec.
	Push and pull strength of knob	0.5kgf static load for 3 sec. (No abnormality in electric characteristics and operating feeling)
	Knob wobble	0.6xL/30 mm p-p max. (L: Knob diameter)
	Shaft stopper strength	0.6Kgf-cm max.
Electrical Characteristics	Nominal total resistance	B50K20% (Terminal 1-3)	(1-3 )
	Resistance law (Taper)	Refer to Taper graph shown	(Taper )
	Insulation resistance	100Mmin. at DC100 volts
	Dielectric strength	Apply AC100 V for 1 min. (between individual terminals and case/shaft)
	End resistance	10max. (Terminal 1-2) 20max. (Terminal 2-3)
	Noise	100mV max.
	Life (no load)	5,000 cycles (1 cycle = CW270+CCW270)/6 sec.
	Maximum operating voltage	AC 50V
	Power rating	0.03W
Lead-Free Soldering Specifications Manual Soldering: Max 350C, within 3 seconds. Automated/Semi-Automated Soldering: Flux specific gravity 0.82, foam height half PCB thickness, no flux on resistive element. Preheat time 2 minutes, PCB underside temp 100C. Solder dipping 260C, within 4 seconds. For plastic shaft with detents, set shaft to a detent position. Soldering process (manual or automated) must not exceed 1 time. Not recommended for reflow soldering.