Electronic Component 49US 5 Megahertz Crystal Oscillator with Temperature Stability KYX KUS050002030

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

- 49US/5.000MHZ

49US/5.000MHZ

: (Kaiyuexiang)
:
:
: 49US/5.000MHZ
: KUS050002030


1. GENERAL ()
HOLDER TYPE ()	49US
MODE OF VIBRATION ()	AT CUT
OSCILLATION MODE ()	FUND S&A
TEST FACILITIES ()	KH-1240
STORAGE TEMPERATURE ()	-40 TO +85
DRIVER LEVEL ()	100W
2. ELECTRICAL PARAMETER ()
NORMAL FREQUENCY ()	5.000 MHz
FREQUENCY TOLERANCE (252) ()	30ppm
TEMPERATURE STABILITY ()	20ppm
OPERATING TEMPERATURE RANGE ()	-20 TO +70
LOAD CAPACITANCE ()	20 PF
MOTIONAL CAPACITANCE ()	5PF	MAX
SHUNT CAPACITANCE ()		250 MAX
EFFECTIVE SERIES RESISTANCE ()		500M OHMS MIN
INSULATION RESISTANCE ()	AT DC 100V
3. MECHANICAL PARAMETER ()
SOLDERABILITY ()	95% COVERAGE BY USING 90/10 SOLD AT 245 FOR 5 SEC. DIPING AFTER IMMERSION IN ALPHA 611 FLUX FOR 5 SEC.
Mechanical Endurance ()
SHOCK ()	Electrical characteristics shall be satisfied after dropping three time from the height of 50 cm onto Hard wooden board.
VIBRATION ()	Electrical characteristics shall be satisfied after supplying following Vibration. (Frequency: 1055Hz, Period: 12min, Amplitude: 1.5mm PP, Direction: X.Y.Z, Time: 2hours/each direction)
STRENGTH OF TERMINALS/LEAD-WIRES ()	PULLING (): Body of specimen shall be fixed, and 900g of tension weight shall be supplied gradually to axial direction of terminals/lead-wires for 30 sec. No visual damages. BENDING (): Body of specimen shall be fixed, and 90degree bending shall be given, being supplied 225gs tension weight. Then straightened gradually. Repeated to opposite direction. No visual damages.
SEALING TIGHTNESS ()	No observation of gas bubble after specimen put in hot water at +90+95 for 5 min.
SOLDERING DIP ()	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +2305 for 3sec. Dipping depth shall be 2mm from the bottom of specimens body. Soldering portion shall be covered in over 90% of terminals/lead-wires dipped. (After applying ROSIN flux)
SOLDER HEATING ()	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +35010 for 3 sec. Dipping depth shall be 2mm from edge of terminals/lead-wires. Electrical characteristics shall be satisfied.
Environmental Endurance ()
HUMIDITY ()	Electrical characteristics shall be satisfied after letting it alone at 602 in humidity of 9095% for 250 hours.
STORAGE IN LOW TEMPERATURE ()	Electrical characteristics shall be satisfied after letting it alone at -302 for 250 hours.
STORAGE IN HIGH TEMPERATURE ()	Electrical characteristics shall be satisfied after letting it alone at +852 for 250 hours.
TEMPERATURE CYCLE ()	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3 cycles). Temperature shift from low to high, high to low shall be done in 1/min.