16 MHz Crystal Oscillator KYX KBD160002020 with 20ppm Frequency Tolerance and AT Cut Vibration Mode

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

49USSMD/16.000MHZ

KBD160002020

20PF/20ppm

(Kaiyuexiang)
TEL0755-89315823 89315866, FAX0755-89315223
www.kaiyuexiang.com

		/
1. GENERAL
HOLDER TYPE	49USSMD
MODE OF VIBRATION	AT CUT
OSCILLATION MODE	FUND S&A
TEST FACILITIES	KH-1240
STORAGE TEMPERATURE	-40 TO +85
DRIVER LEVEL	100W
2. ELECTRICAL PARAMETER
NORMAL FREQUENCY	16.000MHz
FREQUENCY TOLERANCE (252)	20ppm
TEMPERATURE STABILITY	20ppm
OPERATING TEMPERATURE RANGE	-20 TO +70
LOAD CAPACITANCE	20PF
MOTIONAL CAPACITANE	7PF	MAX
SHUNT CAPACITANCE
EFFECTIVE SERIES RESISTANCE	40	MAX
INSULATION RESISTANCE	500M OHMS MIN	AT DC 100V
3. MECHANICAL PARAMETER
SOLDERABILITY	95% COVERAGE BY USING 90/10 SOLD AT 245 FOR 5 SEC. DIPING AFTER IMMERSION IN ALPHA 611 FLUX FOR 5 SEC.
MECHANICAL ENDURANCE
SHOCK	Electrical characteristics shall be satisfied after dropping three time from the height of 50 cm onto Hard wooden board.
VIBRATION	Electrical characteristics shall be satisfied after supplying following Vibration. (VIBRATION FREQUENCY: 1055Hz, REPEATED PERIOD: 12min, FULL CYCLE: 1.5mm PP, DIRECTION: X.Y.Z, TIME: 2hours/each direction)
STRENGTH OF TERMINALS/LEADWIRES (PULLING)	900g of tension weight shall be supplied gradually to axial direction of terminals/lead-wires for 30 sec. No visual damages.
STRENGTH OF TERMINALS/LEADWIRES (BENDING)	90degree bending with 225gs tension weight. No visual damages.
SEALING TIGHTNESS	No observation of gas bubble after specimen put in hot water at +90+95 for 5 min.
SOLDERING DIP	Terminals/lead-wires dipped into solder melted tank at +2305 for 3sec. Dipping depth 2mm from the bottom of specimens body. Soldering portion shall be covered in over 90% of terminals/lead-wires dipped.
SOLDER HEATING	Terminals/lead-wires dipped into solder melted tank at +35010 for 3 sec. Electrical characteristics shall be satisfied. Dipping depth 2mm from edge of terminals/lead-wires.
ENVIRONMENTAL ENDURANCE
HUMIDITY	Electrical characteristics shall be satisfied after letting it alone at 602 in humidity of 9095% for 250 hours.
STORAGE IN LOW TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at -302 for 250 hours.
STORAGE IN HIGH TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at +852 for 250 hours.
TEMPERATURE CYCLE	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3cycles). Temperature shift from low to high, high to low shall be done in 1/min.