Quartz Crystal Resonator KYX KUS240000630 24 MHz frequency stable electronic device component

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

Product Overview: This document specifies the Quartz Crystal Resonator, model 49US/24.000MHZ, manufactured by Shenzhen Kaiyuexiang Electronics Co., Ltd. It is designed for general electronic applications requiring precise frequency control.

Product Attributes:

Brand: Kaiyuexiang
Origin: Shenzhen, China
Manufacturer: Shenzhen Kaiyuexiang Electronics Co., Ltd.
Website: www.kaiyuexiang.com

Parameter	Specification	Details
1. GENERAL
HOLDER TYPE	49US
MODE OF VIBRATION	AT CUT
OSCILLATION MODE	FUND S&A
TEST FACILITIES	KH-1240
STORAGE TEMPERATURE	-40TO +85
DRIVER LEVEL	100W
2. ELECTRICAL PARAMETER
NORMAL FREQUENCY	24.000 MHz
FREQUENCY TOLERANCE (252)	30ppm
TEMPERATURE STABILITY	20ppm
OPERATING TEMPERATURE RANGE	-20TO +70
LOAD CAPACITANCE	6 PF
MOTIONAL CAPACITANCE	5PF MAX
SHUNT CAPACITANCE	40 MAX
EFFECTIVE SERIES RESISTANCE	500M OHMS MIN AT DC 100V
INSULATION RESISTANCE
3. MECHANICAL PARAMETER
SOLDERABILITY	95%COVERAGE BY USING 90/10 SOLD AT 245FOR 5 SEC. DIPING AFTER IMMERSION IN ALPHA 611 FLUX FOR 5 SEC.
Mechanical Endurance
SHOCK	Electrical characteristics shall be satisfied after dropping three time from the height of 50 cm onto Hard wooden board.
VIBRATION	Electrical characteristics shall be satisfied after supplying following Vibration.	(1)VIBRATION FREQUENCY: 1055Hz (2)REPEATED PERIOD: 12min (3)FULL CYCLE: 1.5mm PP (4)DIRECTION: X.Y.Z (5)TIME: 2hours/each direction
STRENGTH OF TERMINALS/LEADWIRES	-1 PULLING: Body of specimen shall be fixed, and 900g of tension weight shall be supplied gradually to axial direction of terminals/lead-wires for 30 sec. After above test a), there is no observation of any visual damages on the specimen. -2 BENDING: Body of specimen shall be fixed, and 90degree bending shall be given, being supplied 225gs tension weight. After that, terminals/lead-wires shall be straightened gradually. Then the same bending and straightening shall be supplied to the opposite direction in the same axial. After above test a), there is no observation of any visual damages on the specimen.
SEALING TIGHTNESS	There is no observation of gas bubble after specimen put in hot water at +90+95for 5 min.
SOLDERING DIP	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +2305 for 3sec. Dipping depth shall be 2mm from the bottom of specimens body. (After applying ROSIN flux) Soldering portion shall be covered in over 90% of terminals/lead-wires dipped.
SOLDER HEATING	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +35010 for 3 sec. Electrical characteristics shall be satisfied after dipping depth shall be 2mm from edge of terminals/lead-wires.
II ENVIRONMENTAL ENDURANCE
HUMIDITY	Electrical characteristics shall be satisfied after letting it alone at 602in humidity of 9095% for 250 hours.
STORAGE IN LOW TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at -302for 250 hours.
STORAGE IN HIGH TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at +852for 250 hours.
TEMPERATURE CYCLE	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3cycles). Temperature shift from low to high, high to low shall be done in 1/min.