Crystal Oscillator KYX KUS1128A2030 11.2896 MHz Frequency with 100W Power and Wide Operating Temperature Range

Name: Crystal Oscillator KYX KUS1128A2030 11.2896 MHz Frequency with 100W Power and Wide Operating Temperature Range
Brand: Beijing Silk Road Enterprise Management Services Co., Ltd.

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

49US/11.2896MHZ

KUS1128A2030

TEL0755-89315823 89315866 FAX0755-89315223

www.kaiyuexiang.com


	49US
	AT CUT FUND
	S&A
	KH-1240
	-40 to +85
	100W
	11.2896	MHz
(252)	30	ppm
	20	ppm
	-20 to +70
	20	PF
	5	PF MAX

	80	MAX
	500	M OHMS MIN AT DC 100V
	95% coverage by using 90/10 sold at 245 for 5 sec. Dipping after immersion in ALPHA 611 flux for 5 sec.
	Electrical characteristics shall be satisfied after dropping three time from the height of 50 cm onto Hard wooden board.
	Electrical characteristics shall be satisfied after supplying following Vibration. (1)VIBRATION FREQUENCY 1055Hz (2)REPEATED PERIOD 12min (3)FULL CYCLE 1.5mm PP (4)DIRECTION X.Y.Z (5)TIME 2hours/each direction
-	Body of specimen shall be fixed, and 900g of tension weight shall be supplied gradually to axial direction of terminals/lead-wires for 30 sec. After above test a), there is no observation of any visual damages on the specimen.
-	Body of specimen shall be fixed, and 90degree bending shall be given, being supplied 225gs tension weight. After that, terminals/lead-wires shall be straightened gradually. Then the same bending and straightening shall be supplied to the opposite direction in the same axial. After above test a), there is no observation of any visual damages on the specimen.
	There is no observation of gas bubble after specimen put in hot water at +90+95 for 5 min.
	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +2305 for 3sec. Dipping depth shall be 2mm from the bottom of specimens body. (After applying ROSIN flux) Soldering portion shall be covered in over 90% of terminals/lead-wires dipped.
	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +35010 for 3 sec. Electrical characteristics shall be satisfied after dipping depth shall be 2mm from edge of terminals/lead-wires.
	Electrical characteristics shall be satisfied after letting it alone at 602 in humidity of 9095% for 250 hours.
	Electrical characteristics shall be satisfied after letting it alone at -302 for 250 hours.
	Electrical characteristics shall be satisfied after letting it alone at +852 for 250 hours.
	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3cycles). Temperature shift from low to high, high to low shall be done in 1/min.