Electronic Component HC 49USSMD 12 MHz Crystal Oscillator KYX KBD12000135515 with Stable Frequency

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

HC-49USSMD/12.000 MHZ
KBD12000135515

(Kaiyuexiang)


GENERAL
Holder Type	HC-49USSMD
Mode of Vibration	AT CUT
Oscillation Mode	FUND S&A
Test Facilities	KH-1240
Storage Temperature	-40 to +85
Driver Level	100	W
ELECTRICAL PARAMETER
Normal Frequency	12.000	MHz
Frequency Tolerance (252)	-5 to +15	ppm
Temperature Stability	20	ppm
Operating Temperature Range	-20 to +70
Load Capacitance	13.5	PF
Motional Capacitance	3	PF MAX
Shunt Capacitance
Effective Series Resistance	80	MAX
Insulation Resistance	500	M OHMS MIN	AT DC 100V
MECHANICAL PARAMETER
Solderability	95% Coverage by using 90/10 Sold at 245 for 5 sec. Dipping after immersion in ALPHA 611 FLUX for 5 sec.


Shock	Electrical characteristics shall be satisfied after dropping three times from the height of 50 cm onto Hard wooden board.	50 cm 3
Vibration	Electrical characteristics shall be satisfied after supplying following Vibration. (1)VIBRATION FREQUENCY 1055Hz (2)REPEATED PERIOD 12min (3)FULL CYCLE 1.5mm PP (4)DIRECTION X.Y.Z (5)TIME 2hours/each direction
Strength of Terminals/Lead-Wires (Pulling)	Body of specimen shall be fixed, and 900g of tension weight shall be supplied gradually to axial direction of terminals/lead-wires for 30 sec. After above test a), there is no observation of any visual damages on the specimen.	900g /30
Strength of Terminals/Lead-Wires (Bending)	Body of specimen shall be fixed, and 90degree bending shall be given, being supplied 225gs tension weight. After that, terminals/lead-wires shall be straightened gradually. Then the same bending and straightening shall be supplied to the opposite direction in the same axial. After above test a), there is no observation of any visual damages on the specimen.	90o 225g 90 o
Sealing Tightness	There is no observation of gas bubble after specimen put in hot water at +90+95for 5 min.	+90+955
Soldering Dip	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +2305 for 3sec. Dipping depth shall be 2mm from the bottom of specimens body. (After applying ROSIN flux) Soldering portion shall be covered in over 90% of terminals/lead-wires dipped.	+23053 2mm90
Solder Heating	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +35010 for 3 sec. Electrical characteristics shall be satisfied after dipping depth shall be 2mm from edge of terminals/lead-wires.	+350103-4 2mm


Humidity	Electrical characteristics shall be satisfied after letting it alone at 602in humidity of 9095% for 250 hours.	6029095%250
Storage in Low Temperature	Electrical characteristics shall be satisfied after letting it alone at -302for 250 hours.	-302250
Storage in High Temperature	Electrical characteristics shall be satisfied after letting it alone at +852for 250 hours.	+852250
Temperature Cycle	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3cycles). Temperature shift from low to high, high to low shall be done in 1/min (Refer to Fig-2).	3 1/2

TEL0755-89315823 / 89315866
FAX0755-89315223
www.kaiyuexiang.com