HC49USSMD 10 MHz Crystal Oscillator with 20PF Load Capacitance KYX KBD100002030 Frequency Stability

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

HC-49USSMD/10.000 MHZ

20PF/30ppm

KBD100002030

HC-49USSMD/10.000 MHZ

(Kaiyuexiang)


GENERAL
HOLDER TYPE	HC-49USSMD
MODE OF VIBRATION	AT CUT
OSCILLATION MODE	FUND S&A
TEST FACILITIES	KH-1240
STORAGE TEMPERATURE	-40TO +85
DRIVER LEVEL	100W
ELECTRICAL PARAMETER
NORMAL FREQUENCY	10.000 MHz
FREQUENCY TOLERANCE252	30ppm	252
TEMPERATURE STABILITY	20ppm
OPERATING TEMPERATURE RANGE	-20TO + 70
LOAD CAPACITANCE	20 PF
MOTIONAL CAPACITANCE	3PF MAX
SHUNT CAPACITANCE
EFFECTIVE SERIES RESISTANCE	80MAX
INSULATION RESISTANCE	500M OHMS MIN AT DC 100V
MECHANICAL PARAMETER
SOLDERABILITY	95%COVERAGE BY USING 90/10 SOLD AT 245FOR 5 SEC. DIPING AFTER IMMERSION IN ALPHA 611 FLUX FOR 5 SEC.
MECHANICAL ENDURANCE
SHOCK	Electrical characteristics shall be satisfied after dropping three time from the height of 50 cm onto Hard wooden board.	50cm3
VIBRATION	FREQUENCY 1055Hz, REPEATED PERIOD 12min, FULL CYCLE 1.5mm PP, DIRECTION X.Y.Z, TIME 2hours/each direction	1055Hz12min1.5mm PPX.Y.Z2/
STRENGTH OF TERMINALS/LEADWIRES	PULLING: 900g tension for 30 sec. BENDING: 90 degree bending with 225gs tension weight.	900g225g
SEALING TIGHTNESS	No gas bubble after specimen put in hot water at +90+95 for 5 min.	+90+955
SOLDERING DIP	Dipped into solder melted tank at +2305 for 3sec. Dipping depth 2mm from the bottom of specimens body. Soldering portion shall be covered in over 90% of terminals/lead-wires dipped.	+2305390%
SOLDER HEATING	Dipped into solder melted tank at +35010 for 3 sec.	+350103
ENVIRONMENTAL ENDURANCE
HUMIDITY	Electrical characteristics shall be satisfied after letting it alone at 602 in humidity of 9095% for 250 hours.	6029095%250
STORAGE IN LOW TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at -302 for 250 hours.	-302250
STORAGE IN HIGH TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at +852 for 250 hours.	+852250
TEMPERATURE CYCLE	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3cycles). Temperature shift from low to high, high to low shall be done in 1/min.	31/min