Precision HC 49SS 12.000MHz Quartz Crystal Oscillator with 7pf Max Load Capacitance KYX KSS120002030

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

- HC-49SS/12.000MHZ

HC-49SS/12.000MHZ

:
:
: HC-49SS/12.000MHZ
: KSS120002030



	HC-49SS/12.000MHZ
-	49USS AT CUT
-	FUND S&A
-	KH-1240
-
-	-40 TO +85
-	100W
-	12.000 MHz
- (252)	30ppm
-	20ppm
-	-20 TO +70
-	20 PF
-	7PF MAX
-
-	80 MAX
-	500M OHMS MIN AT DC 100V
-	95% COVERAGE BY USING 90/10 SOLD AT 245 FOR 5 SEC. DIPING AFTER IMMERSION IN ALPHA 611 FLUX FOR 5 SEC.
-	Electrical characteristics shall be satisfied after dropping three time from the height of 50 cm onto Hard wooden board.
- -	1055Hz
- -	12min
- -	1.5mm PP
- -	X.Y.Z
- -	2hours/each direction
- -	Body of specimen shall be fixed, and 900g of tension weight shall be supplied gradually to axial direction of terminals/lead-wires for 30 sec. After above test a), there is no observation of any visual damages on the specimen.
- -	Body of specimen shall be fixed, and 90degree bending shall be given, being supplied 225gs tension weight. After that, terminals/lead-wires shall be straightened gradually. Then the same bending and straightening shall be supplied to the opposite direction in the same axial. After above test a), there is no observation of any visual damages on the specimen.
-	There is no observation of gas bubble after specimen put in hot water at +90+95 for 5 min.
-	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +2305 for 3sec. Dipping depth shall be 2mm from the bottom of specimens body. (After applying ROSIN flux) Soldering portion shall be covered in over 90% of terminals/lead-wires dipped.
-	Terminals/lead-wires of specimen shall be dipped into solder melted tank at +35010 for 3 sec. Electrical characteristics shall be satisfied after dipping depth shall be 2mm from edge of terminals/lead-wires.
-	Electrical characteristics shall be satisfied after letting it alone at 602 in humidity of 9095% for 250 hours.
-	Electrical characteristics shall be satisfied after letting it alone at -302 for 250 hours.
-	Electrical characteristics shall be satisfied after letting it alone at +852 for 250 hours.
-	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3cycles). Temperature shift from low to high, high to low shall be done in 1/min.