Electronic Component KYX KSD1105A2030 11.0592 MHz Crystal Oscillator HC49USSMD 20PF Load Capacitance

Price Negotiable

Price: Negotiable

MOQ: Negotiable

Delivery Time: Negotiable

Product Description

HC-49USSMD/11.0592 MHZ

20PF/30ppm

KSD1105A2030

(Kaiyuexiang)


GENERAL
HOLDER TYPE	HC-49USSMD
MODE OF VIBRATION	FUND
OSCILLATION MODE	S&A
TEST FACILITIES	KH-1240
STORAGE TEMPERATURE	-40TO +85
DRIVER LEVEL	100W
ELECTRICAL PARAMETER
NORMAL FREQUENCY	11.0592MHz
FREQUENCY TOLERANCE252	30ppm
TEMPERATURE STABILITY	20ppm
OPERATING TEMPERATURE RANGE	-20TO + 70
LOAD CAPACITANCE	20 PF
MOTIONAL CAPACITANE	5PF MAX
SHUNT CAPACITANCE
EFFECTIVE SERIES RESISTANCE	80MAX
INSULATION RESISTANCE	500M OHMS MIN	AT DC 100V
MECHANICAL PARAMETER
SOLDERABILITY	95%COVERAGE BY USING 90/10 SOLD AT 245FOR 5 SEC. DIPING AFTER IMMERSION IN ALPHA 611 FLUX FOR 5 SEC.
MECHANICAL ENDURANCE		Provided that measurement shall be carried out after letting it alone in the room temperature for 1 hour.
SHOCK	Electrical characteristics shall be satisfied after dropping three time from the height of 50 cm onto Hard wooden board.
VIBRATION	Electrical characteristics shall be satisfied after supplying following Vibration.
VIBRATION FREQUENCY	1055Hz
REPEATED PERIOD	12min
FULL CYCLE	1.5mm PP
DIRECTION	X.Y.Z	2 hours/each direction
STRENGTH OF TERMINALS/LEADWIRES (PULLING)	900g tension weight for 30 sec.	No visual damages.
STRENGTH OF TERMINALS/LEADWIRES (BENDING)	90 degree bending with 225gs tension weight.	No visual damages.
SEALING TIGHTNESS	No observation of gas bubble after specimen put in hot water at +90+95for 5 min.
SOLDERING DIP	Terminals/lead-wires dipped into solder melted tank at +2305 for 3sec. Dipping depth 2mm from bottom of specimens body.	Soldering portion shall be covered in over 90% of terminals/lead-wires dipped.
SOLDER HEATING	Terminals/lead-wires dipped into solder melted tank at +35010 for 3 sec.	Electrical characteristics shall be satisfied. Dipping depth 2mm from edge of terminals/lead-wires.
ENVIRONMENTAL ENDURANCE		Provided that measurement shall be carried out after letting it alone in the room temperature for 1 hour.
HUMIDITY	Electrical characteristics shall be satisfied after letting it alone at 602 in humidity of 9095% for 250 hours.
STORAGE IN LOW TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at -302 for 250 hours.
STORAGE IN HIGH TEMPERATURE	Electrical characteristics shall be satisfied after letting it alone at +852 for 250 hours.
TEMPERATURE CYCLE	Electrical characteristics shall be satisfied after supplying the following temperature cycle (3 cycles). Temperature shift from low to high, high to low shall be done in 1/min.