2069016300-ZC E-Drive System Fluid Heat Exchanger for Geely Geometry A G6 / Emgrand GSE

2069016300-ZC E-Drive System Fluid Heat Exchanger for Geely Geometry A G6 / Emgrand GSE

Product Introduction

Engineered specifically for the high-power-density electric drive architecture of Geely’s EV platform—including the Geometry A, Geometry G6, and Emgrand GSE—this primary e-drive fluid heat exchanger directly replaces OEM part 2069016300-ZC. It provides active temperature regulation for the traction motor assembly, power control unit (MCU), and onboard charging electronics.

Specification

Key Features

3D-Mapped OE Geometry Alignment: Built using direct spatial scans of the original 2069016300-ZC housing, guaranteeing precise retention pin seating, factory fan shroud mounting, and stress-free alignment for quick-disconnect coolant lines.

Low-Hydraulic-Resistance Micro Channels: Built with high-frequency welded AA3003 aluminum tubing designed to keep internal pressure loss below 15 kPa at nominal flow rates, ensuring steady coolant turnover under heavy thermal loads.

Structural Polymer Tank Assemblies: End tanks are injection-molded from heat-stabilized PA66-GF30 engineering composite and crimped with dynamic EPDM seals to prevent seam leakage under continuous pressure pulses and thermal expansion.

Dynamic Helium Mass Spectrometer Testing: Every production unit is subjected to automated multi-bar pressure decay and helium trace-gas inspection prior to boxing, eliminating micro-porosity and guaranteeing long-term fluid containment.