Reusable SpO2 Sensor

A brand new, patient compatible, directly connected adult hard shell finger SpO2 sensor compatible with Mindray. This SpO2 sensor is compatible with Mindray SpO2 monitoring equipment and has a 7-pin connector and a 10FT/3M long cable. Use the monitor/module compatibility table below to check if the selected cable is compatible with the patient monitor being used. If you are still unsure, please contact us to understand the prerequisites for compatibility. 1. Product Name :

The principle of a pulse oximeter was developed by Takuo Aoyagi, a Japanese Kohden researcher, in the early 1970s. The pulse oximeter measures oxygen saturation (SpO2) non invasively through the infrared sensor on the fingertip. Before that, the measurement of oxygen saturation required arterial blood sampling. With the help of pulse oximeter, the key parameters of oxygen saturation can be measured painlessly, continuously and in real time. 1. Product Name : Nihon Kohden MU

SpO2 sensors work by emitting light at two different wavelengths (usually red and infrared) through the tissue and detecting the amount of light that is absorbed by the oxygenated and deoxygenated hemoglobin in the blood. Based on the ratio of absorbed light at each wavelength, the sensor can determine the oxygen saturation level in the blood. 1. Product Name : Biolight SpO2 Sensor Probe A series 9Pin Digital Tech Adult Soft Clip SpO2 2. Compatibility: Compatible for A Series

1. Product Name : Biolight M8000 M9000 SpO2 Sensor Digital 5Pin Adult Finger Clip SpO2 Probe 2.OEM Part Number Cross References: Manufacturer OEM Part Biolight 15-100-0010 3.Compatibility: Manufacturer Model Name Biolight M12, M6, M66, M69, M8000, M8000A, M8500, M9000, M9000A, MTD-352A Biocare BM-9000S Sunnex M8000A, M9000, Q5 4.Technical Parameters Comparative value measurement in % saturation: Range 70%-80% --- Accuracy ± 3%; Range 80%-100% --- Accuracy ± 2%; SPO2 Range ( <

Compatible C-ovidien N-ellcor Short SpO2 Sensor Adult Soft Tip 1M For short-term or "spot check" monitoring. Recommended monitoring site: Ring or middle of non-dominant hand. Sensor must be repositioned every 4 hours. With for M-asi-mo rainbow set technology Using for M-asi-mo pulse oximeters connected to rainbow tech-enabled devices, clinicians can non-invasively monitor total hemoglobin (SpHb®), carboxyhemoglobin (SpCO), methemoglobin (SpMet) and oxygen levels (SpOC), as

1. Product Name : Creative UP-7000 PC-3000 Adult Finger Clip SpO2 Sensor 9Pin 3.0M SpO2 Probe Medical grade TPU cable, about 300 cm long cablecable easy to clean from dirty and blood,long lifetime for normal use,not easy to broken3. Replacement for patient monitor4. Connector white plastic 9 pin5. Warranty 6 months 1. Brand new,2. OEM available,3. Quality 100% assured,4. Superior flexibility and durability,Aluminum foils shielding,5. Materials of connector and cable comply

This compatible sensor connects directly to the bedside monitor.Reusable pulse oximeter sensor is designed to measure the level of saturation (oxygen saturation) of the patient's blood. 1. Product Name : Infinium OMNI Spo2 sensor 10Pin P02111 Omni I II III DRE Infitron II Direct-Connect SpO2 Probe 2. OEM Part Number Cross References: DRE P02111 3. Compatibility: Manufacturer Model Axia Surgical V1050T DRE Pro, Touch, Waveline EZ Infinium Infitron II, Omni II, Omni III, Omni K

1. Product Name Mindray 509 507 509 Reusable SpO2 Sensor 5 Pin Adult Finger Clip SpO2 Sensor 2. Description of Reusable SpO2 Sensor Mindray 509 507 509 Reusable SpO2 Sensor 5 Pin Adult Finger Clip SpO2 Sensor SpO2 sensors are an important tool in the treatment of respiratory conditions because they provide a non-invasive way to monitor a patient's oxygen saturation levels. Oxygen saturation is a measure of the percentage of hemoglobin molecules in the blood that are carrying

How can I use a SpO2 sensor at home? 1.Choose the right sensor: There are different types of SpO2 sensors, such as finger sensors or earlobe sensors. Choose the type of sensor that is most suitable for you and your needs. 2.Prepare the sensor: Make sure the sensor is clean and dry before use. If using a finger sensor, remove any nail polish or artificial nails that may interfere with the measurement. 1. Product Name : Anke ASC-553A SpO2 Sensor Ohmeda Tech 7Pin Adult Finger

Compatible Comen C70 C60 Comen SpO2 Probe 3.0M M-asimo Oxmax Tech. BestMed--- Patient Monitoring & Diagnostic Cables ... 1. Product Name : Compatible Comen C70 C60 Comen SpO2 Probe 3.0M M-asimo Oxmax Tech. 2. Compatibility: Manufacturer Model For Comen C30 C60 C70 C80 C Series 3. Technical Parameters Comparative value measurement in % saturation: Range 70%-80% --- Accuracy ± 3%; Range 80%-100% --- Accuracy ± 2%; SPO2 Range ( < 69%) --- no specified Pluse Rate :Pluse rate

Compatible Infinium Infant Soft Tip Direct SpO2 Probe 3M 6Pin for Waveline EZ MAX Waveline Pro. For short-term or "spot check" monitoring. Recommended monitoring site: Ring or middle of non-dominant hand. Sensor must be repositioned every 4 hours. With for M-asi-mo rainbow set technology Using for M-asi-mo pulse oximeters connected to rainbow tech-enabled devices, clinicians can non-invasively monitor total hemoglobin (SpHb®), carboxyhemoglobin (SpCO), methemoglobin (SpMet)

How to use finger pulse oximeter or finger clamp sensor? 1) Squeeze the rear labels of the SPO2 sensor together and open the clamping device of the sensor. 2) Place your index finger on the SPO2 sensor window and press your fingertips against the bezel. Note: If you are unable to locate your finger correctly or if your index finger cannot be used, you can use a smaller finger. In some cases, if your nails are longer, the tip of the nail can extend onto the finger guard. 3)

How can I use a SpO2 sensor at home? Wait for the reading: Once the device is initialized, it will begin to read your oxygen saturation levels. Wait for a few seconds until the reading stabilizes. 1. Product Name : Artema Diascope 800 SpO2 Sensor Digital 10Pin Adult Finger Clip SpO2 Probe 2. Compatibility: Compatible for Artema Diascope 8000 Anthena( non Oxi-max) 3. Other Models and products Part Number Type Picture BSB310-04 Adult Soft Tip BSC310-04 Pediatric Finger Clip

Compatible Zondan ZD120B ZD120D 6Pin SpO2 Sensor 3.0M Pediatric Finger Clip for Apollo N1 Apollo N2 Apollo N3. For short-term or "spot check" monitoring. Recommended monitoring site: Ring or middle of non-dominant hand. Sensor must be repositioned every 4 hours. With for M-asi-mo rainbow set technology Using for M-asi-mo pulse oximeters connected to rainbow tech-enabled devices, clinicians can non-invasively monitor total hemoglobin (SpHb®), carboxyhemoglobin (SpCO),

Compatible Osen 8000B Adult Finger Clip Direct SpO2 Sensor 3M 5Pin 40Degree. For short-term or "spot check" monitoring. Recommended monitoring site: Ring or middle of non-dominant hand. Sensor must be repositioned every 4 hours. With for M-asi-mo rainbow set technology Using for M-asi-mo pulse oximeters connected to rainbow tech-enabled devices, clinicians can non-invasively monitor total hemoglobin (SpHb®), carboxyhemoglobin (SpCO), methemoglobin (SpMet) and oxygen levels

1. Product Name : GE Datex Ohmeda SpO2 Sensor Cable 10Pin To DB9 SpO2 Adapter Extension Cable AS/3 CS/3 Capnomac Ultima Cardiocap 2. Description of SpO2 Sensor Cable: The for Datex Ohmeda compatible SpO2 sensor cable is 10Pin to DB9 Pin connector with a length of 2.4M for for Datex technology. It connects to the for Datex Ohmeda spo2 sensor and matches for Datex tech patient monitor to observe continuous non-invasive monitoring of functional oxygen saturation (SpO2) and pulse

Compatible FAZZINI PMS 8000D 12Pin Pediatric Direct SpO2 Sensor 3M. BestMed--- Patient Monitoring & Diagnostic Cables ... 1. Product Name : Compatible FAZZINI PMS 8000D 12Pin Pediatric Direct SpO2 Sensor 3M. 2. Compatibility: Manufacturer Model Number For FAZZINI PMS 8000D 3. Technical Parameters Comparative value measurement in % saturation: Range 70%-80% --- Accuracy ± 3%; Range 80%-100% --- Accuracy ± 2%; SPO2 Range ( < 69%) --- no specified Pluse Rate :Pluse rate range :

Compatible Contec 6Pin SpO2 Sensor 3.0M Digital Tech Animal Rectal CMS5100,CMS800, CMS9000C,CMS9100. For short-term or "spot check" monitoring. Recommended monitoring site: Ring or middle of non-dominant hand. Sensor must be repositioned every 4 hours. With for M-asi-mo rainbow set technology Using for M-asi-mo pulse oximeters connected to rainbow tech-enabled devices, clinicians can non-invasively monitor total hemoglobin (SpHb®), carboxyhemoglobin (SpCO), methemoglobin

1. Product Name : Biocare im7 Spo2 sensor 6 Pin Neonate Wrap SpO2 Probe 2.OEM Part Number Cross References: Biocare IM7 3.Compatibility: Biocare IM7 4.Technical Parameters Comparative value measurement in % saturation: Range 70%-80% --- Accuracy ± 3%; Range 80%-100% --- Accuracy ± 2%; SPO2 Range ( < 69%) --- no specified Pluse Rate :Pluse rate range : 20-250 bpm --- Accuracy ± 3digits ; 5. Other Models and products Part Number Type BSB306-12 Adult Soft Tip BSC306-12 Pediatric

1. Product Name : Creative K12 Adult Finger Clip SpO2 Sensor 8Pin 3.0M SpO2 Probe Medical grade TPU cable, about 300 cm long cablecable easy to clean from dirty and blood,long lifetime for normal use,not easy to broken3. Replacement for patient monitor4. Connector blue round 8Pin5. Warranty 6 months 1. Brand new,2. OEM available,3. Quality 100% assured,4. Superior flexibility and durability,Aluminum foils shielding,5. Materials of connector and cable comply with UL and Rohs