China aac Autoclaved aerated concrete blocks professional Manufacturer

The using unit and the construction unit should check the technical documents and parts inventory together before installation. Autoclaved concrete device must be completely repaired before installation and use, if there are some dangerous happening to autoclaved device during the transportation.

1. Product certificate, quality certificate, installation instructions and the general layout, diagram of main component and other technical information must be complete, if not, autoclaved concrete device is not allowed to install and use.
2. Installation work of autoclaved concrete device must be completed in accordance with the diagram and the installation instructions and other relevant technical requirements and provisions to ensure construction quality.
3. Locate block iron of face of bearing will be welded in the kettle body to make each bearing in axial and the kettle body with no relative motion, clean up the Sunday at the bottom to make the roller can move freely.
4. The device of hoisting kettle cover make the distance between pot cover and the flange horizontal centerline of kettle body not greater than 2mm. adjust the upper gland nut of the kettle lid to make kettle cover and the flange of kettle body basic parallel or allow some clearance at the bottom. So that we can make the kettle lid without phenomenon of lay particular stress on and can stay in any position.
5. Cleaning and grinding the inner wall of the seal groove, coated graphite powder lubrication and put sealing ring, uniform tightness around and then close the kettle cover. The reducer rotate kettle cover to make the 44 tooth pitch.

u can also visit my website"www.xindaboiler.com" u will get more information about product and our company.