Nitrile Diaphragm For Water Solenoid Valve 2'' 2W500-50 2S500-50

Diaphragm ( Membrane ) for 2'' solenoid valve 2W500-50, 2S500-50. Selecting the correct material for your solenoid valve diaphragm, requires an understanding of available materials.

1. NBR
The chemical name for Nitrile rubber is Nitrile Butadiene Rubber. However, most commonly it is referred to as NBR or Buna-N. NBR is probably the most common solenoid valve seal material and it is considered the standard material for neutral fluids by many. NBR can stand working temperatures from -10 °C up to approximately 90°C on a continuous basis, and higher temperatures intermittently. NBR resists aging caused by heat very well. NBR's resistance to sunlight is very poor however abrasion and tear resistance of NBR is very good.

2. EPDM
EPDM stands for Ethylene Propylene Diene Monomer rubber. EPDM solenoid valve seals are well suited for use with hot waterand steam due to EPDM's excellent resistance to heat. The working temperatures of EPDM is approximately between -10 °C to +140 °C. EPDM is unsuitable for use with most oils and fuels.

3. Viton
Viton(FKM) is well known for its excellent heat resistance, and is suitable for use with oils, combustible gases, fuels, solvents. The working temperatures range from -10°C to + 140 °C.

Ordering Code of Diaphragm For Water Solenoid Valve:

Dimension of 2'' Water Solenoid Valve Diaphragm:

Video of 2'' Water Solenoid Valve Diaphragm:

Pictures of Solenoid Valve Membrane Production:

More Products For Water Solenoid Valve for you to choose:

Brass Water Solenoid Valve	Stainless Steel Water Solenoid Valve
Solenoid Coil	Solenoid Armature

Focus on your demands, Offer you best solution:

√ Contact us if some points you have doubt

√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for

√ Contact us if you are doing designing

Welcome to your any question and inquiry!