CA45FS 1.5" Flange Type Pulse Valve AC110V AC220V DC24V

Description of FS Series Pulse Jet Valve:
CA45FS Nitrile NBR diaphragm pulse valve with flanged inlet port and slide seal outlet port for easy valve installation and removal. A diaphragm valve that is controlled by a pilot valve such as electromagnetic or pneumatic, and can open and close a high-pressure gas source to generate a pulse.

Techincal data of Goyen type FS series Dust Collector Diaphragm Valve:

Overall dimension of 1 1/2 Inch Dust Collector Pulse Solenoid Valve:

YouTube video of CA45FS Goyen Replacement Dust Collector Pulse Valve:

Spare part pictures of CA45FS Reverse Pulse Jet Solenoid Valve:

Construction:
1. Body: Diecast Aluminium
2. Ferrule: 304 SS
3. Armature: 430FR SS
4. Seals: Nitrile or Viton (reinforced)
5. Spring: 304 SS
6. Screws: 302 SS
7. Outlet Slide Seals: EPDM or Viton
8. Diaphragm Seat: PA-6 (standard), Viton coated mild steel

Features:
1. Range of sizes and configurations for flexibility in system specification.
2. Engineered and tested for optimal performance and durability.
3. Reduced number of valve fittings necessary.
4. Solenoid coils available in standard AC and DC voltages.
5. Complies with current regulations.
6. Spare parts kits readily available.

Five tips for extending the life of Goyen type FS series flange connection pulse jet valve for dust collector bag filter:

1. First ensure that the voltage of the dust collector pulse jet valve is stable when in use.

2. The air supply pressure of the dust collector must be too low or the dust source is unstable. Before use, it is necessary to check the wiring line of the dust removal trouble regularly.

3. Replace the defective dust collector pulse jet valve parts in time. In the environment with temperature difference, the dust collector pulse jet valve should be used with the oil water separator.

4. The newly installed dust collector first cleans the solder joint impurities in the air bag.

5. Ensure that the clean air temperature of the valve body entering the dust collector pulse jet valve is not lower than -5 °C.

Focus on your demands, Offer you best solution:

√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing

Welcome to your any question and inquiry!