IEC 60468 DC Low Resistance Conductor Resistivity Tester for Wire and Cable

Usage:

The equipment used to test the resistance of a conductor of a unit length (such as wire and cable) is the equipment used in laboratories, wire production sites, quality control departments, and wire and cable manufacturers.

Conductor resistance fixture:

Meet the requirements of GB3048.2, GB3048.4, GB 5013, GB5023, IEC 60245-2, IEC 60227, IEC 60468 and other requirements.

Measuring wire length: 1m

The largest measuring section: 120mm2 (diameter: 0.5~12mm); 2000mm2 (maximum diameter: 25mm); 8000mm2 (maximum diameter: 50mm)

Current and voltage terminal spacing: 60mm

The fixture is used with a bridge or a DC low resistance tester, which can greatly reduce the error of measurement. The clamp has two sets of interchangeable chucks and a pair of miniature terminals. The current end is shaped as a right-angled tiger mouth and can make the current end The sample is in good contact, so that the current is evenly distributed in the core to be measured, reducing the influence of the contact resistance on the measurement; suitable for measuring the DC resistance of the conductors of the round wire, stranded wire and fan wire, and also measuring the following 0.1 mm Specifications enameled wire.

DC low resistance tester:

DC low-resistance tester is an intelligent, wide-range and precise DC resistance tester. It is suitable for transformer and inductor copper resistance, relay contact resistance, switch, connector contact resistance, wire resistance, component solder contact resistance, and printing. Board lines and solder hole resistance, metal detection and so on. Applied to the production line, you can use the HANDLER interface and GPIB interface (option) to output good/bad signals to improve the automated testing capabilities of the production line.

Basic accuracy 0.1% reading + 2 words

Display range 0.001 mΩ to 19.999 kΩ

Test Current 1 A, 100 mA, 10 mA, 1 mA, 100 μA

Range 20 mΩ, 200 mΩ, 2 Ω, 20 Ω, 200 Ω, 2 kΩ, 20 kΩ

Each range resolution 1 μΩ, 10 μΩ, 100 μΩ, 1 mΩ, 10 mΩ, 100 mΩ, 1 Ω

Measurement speed (times/second) Fast: 10, Slow speed: 2.5

Range mode Automatic, keep

Operating temperature, humidity 0°C — 40°C, ≤90% RH

Power Requirements 198 V - 242 V AC, 47.5 Hz - 52.5 Hz

Power consumption ≤30 VA

Size (W×H×D) 270 mm×110 mm×330mm

Weight about 3.3 kg