GCr15 CZ Purlin Machine
Easy Mounting CZ Purlins Making Machine Purlin Machine Sold To Argentina
The key points for the safe use of C/Z interchange purlin machine(CZ purlin roll forming machine)
First, before each start of operation, you need to check whether the connection of the C/Z interchange purlin machine is reliable, the relevant bolts, nuts and so on have not been tightened, to know that the bolts and nuts are loose and off, may affect the operation of the production and processing.
Secondly, before the production process, make sure that the purlin machine equipment chassis has enough oil so that it can be powered on to start the equipment to run.
Third, because each production processing purlin size, shape and specifications may differ to some extent, we need to figure out the requirements of this processing before each operation, and then pay attention to the placement of the mold, to ensure that the surrounding space is uniform, and in the process of operation there is enough space.
Fourth, in the installation of the mold, you must block the power to do, this time you need to be careful to move the motor belt or the corresponding large gear, so as to better install the mold.
Fifth, in the daily production and processing process, we must close the electrical cabinet and junction box of the C/Z interchange purlin machine to avoid the phenomenon of dirt accumulation, and we are advised to check the corresponding joints regularly to avoid the phenomenon of oil leakage.
Sixth, every once in a while must check the accumulator inflation pressure is in line with the requirements, the capsule has no abnormal phenomenon, once the problem is found must be dealt with in a timely manner, in addition, in the process of operation need to maintain the stability of the working voltage, remember not to let the fluctuation value exceeds the C / Z interchange purlin machine rated voltage of about five percent, the maximum fluctuation value can not exceed ten percent. (Steel frame roll forming machine)
| Easy Mounting CZ Purlins Making Machine Purlin Machine Sold To Argentina | |
| Uncoiling |
Hydraulic type 5.5kw+3kw 3 Tons capacity |
| Roll forming machine |
Guiding Hydraulic cut to cut the head and tail of steel coil Roll forming 18 stands GCr15 rollers 40Cr shafts Flying punch to make holes Flying cut to cut length of profile |
| Out table | 2 pieces of 2 meters |
| Working speed | 10-20m/min with perforation |
| Voltage | 380V 50Hz |
| Control panel | Siemens PLC controlled |
| Hydraulic station | 11kw |
Flow chart of CZ purlin roll forming machine:
Hydraulic decoiler with leveler--Servo feeder with hydraulic punch stands--Guiding--Roll forming machine--Hydraulic flying cut
Pictures of CZ purlin roll forming machine:
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.