Two Component Polyether Polyols Chemical PU Adhesive Gule For Air Filter / Air Filters Material

1. Product introduction

Two-component polyurethane adhesive for machine

component proportion ratio is 100:25

2. Parameter table

3. Product characteristics

Material-A:Small barrel :25KGBig barrel :50KG

orange-red viscous liquid (color based on your request to configure)

4. Product principle

1.The material must be full rocked after each to the plastic injection machine plastic injection so that the A material mixing evenly.

1.Everytime the plastic injection machine plastic injection A material must be full before the shaking in order to the material until

2.AB material proportioning ratio of A:B=100:25 or 4:1.28°C,you can start operation

3.Material temperature controlled 24°C-28°C appropriate then you can start operation.

4. Must be clean before using the mould release agent (Note:

The new plastic mould can be wiped free)

5 .If A and B is not reaction please measuring A and B ratio.

6. A and B must be sealed to .To avoid the air and water vapor reaction, as a result affecting the effect of colloidal