IPX3 IPX4 Handheld Nozzle Water Spray Water Ingress Testing Equipment
IPX3 IPX4 Handheld Nozzle Water Spray Water Ingress Testing Equipment
Complied Standards & Clauses
IEC 60529-2013 “Degrees of protection provided by enclosure (IP code)” IPX3 and IPX4, Figure 5.
IEC 60598-1-2017 “Luminaries-Part1: General requirements and tests”
Equipment Overview
The spray nozzle is used to verify the protective performance of the enclosure for electronic and electrical products, automobiles, motorcycle parts, household appliances, seals and lamps under water spraying and splashing at degree IPX3 and IPX4. The water pressure can be adjusted using the flow control handle on the device to give the required flow rate. The pressure can be seen on the gauge which is conveniently positioned by the nozzle. A movable shield can be put down over a portion of the nozzle for IPX3 or moved out of the spray pattern for IPX4.
Technical Parameters
| Parameters of Spray Nozzle | Outer diameter: Ф102mm, spherical diameter: SФ75.5mm, 1 hole at the center, 2 inner circles of 12 holes at 30° pitch,4 outer circles of 24 holes at 15° pitch, total 121 holes of Ф0.5mm, made of brass. |
| Water Flow | 10L/min±5% adjustable by flow meter (flow meter is not included in this item, should be prepared by user) |
| Pressure | 50～150Kpa, the pressure gauge measuring range: 0～0.25Mpa |
| Moving Shield |
Made of aluminum, can be detachable Note: the aluminum moving shield is easy to deform, pay attention during use |
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.