Specification

Usage of Polyacrylamide

1. Polyacrylamide can't be put directlr into sewage, so dissolve in water before using Polyacrylamide.
2. The dissolved water should be clean water, and without heating, but the temperature can't be cold. The temperature is higher than five degress Celsius. Otherwise it will be dissolve very slowly. Temperature above 40 degrees Celsius affect the use effect.
3. Notice: Don't use strong acid, strong base, high salt water preparation.
4. The ratio range is recommended to be between 0.1% and 0.3%. For example, 1 liter of water with 1~3g of agents.
5. If because of other reasons, the dispersion is not good, we suggest that you mix a little more sparse.
6. The water is warmer in Summer. Cationic, Anionic Polyacrylamide should be strict for about 1 hour. Nonionic Polyacrylamide should be strict for about 2 hours.
7. The water is cold in Winter, Cationic, Anionic Polyacrylamide should be strict for about one and a half hours. Nonionic Polyacrylamide should be strict for about 3 hours.

Application Fields