H Steel Snowmobile Dolly Cart

High-performance and high-bearing capacity snowmobile snow outdoor tool anti-skid kit

Description:

High quality high performance high load capacity for snowmobiles Strong support surface with rust resistant powder coating. Two front wheel shapes available. 1500 lbs. load capacity (set) Sturdy steel plate design, 2-3/8 inch hard rubber casters Three piece set allows for minimal gap turns and safe control of the snowmobile in storage areas. 1500 lbs. high load capacity, essential for winter snowmobiles, adjustable nylon straps, rear cart with four steel carts. Strap it to the snowmobile and you can easily start the snowmobile. Swivel casters allow for maneuvering in tight spaces, and sturdy adjustable nylon straps. Allows you to easily move snowmobiles on the ground or in the garage

QA:

How do you tie the belt?

Answer:Pass the non-loop end of the strap through a slot on the top edge of the cart. Then pass the non-loop end of the strap through the loop end and tighten it. Then connect one end of the strap to the cart. Put the snowmobile skis on the trolley. Put the strap on the ski and pass it through another slot on the top edge of the trolley. Pull tight and return to the top of the ski, then push the Velcro pieces together.

Whats the best way to get your sled on this?

Each front ski one at a time first. If you pull upward on front of ski you can slide them into place. Next place rear dooly next to track at spot you want track to set upon it. Lift back straight up high enough to clear rear dolly and move rear of sleds over dolly and lower into place. Fairly simple to do.

Service:

If you have any questions about the products you have purchased, you can consult our customer service. If you have any questions, you are welcome to contact us online, email, or phone!