MGP Series Compact Cylinder Compressed Air Hydraulic

Caution
4. Do not mount the cylinder or actuator with the auto switch on a footing.
If work personnel gets on or puts their foot on the footing accidentally, an excessive load is applied to the cylinder or actuator, causing the cylinder or actuator to break.
5. Design the circuit to prevent backflow in the event of short-circuit problems or when forced operation is performed to check the operation.
If backflow occurs, this may cause the switch to malfunction or break.
6. When multiple auto switches are required
“n” indicates the number of auto switches which can be physi- cally mounted on a cylinder/actuator. Detection intervals depend on the auto switch mounting structure and set position, therefore some required intervals and set positions may not be available.
7. Limitations on detectable position
There are positions and surfaces (bottom surface of the foot bracket, etc.) where the auto switch cannot be mounted due to physical interference depending on the cylinder or actuator mounting status or mounting bracket. Select an appropriate auto switch setting position where the auto switch does not in- terfere with the cylinder or actuator mounting bracket (trunnion or reinforcing ring) after checking it sufficiently.