Base Oil 200L/Min Circulating Oil System Thin Oil Lubrication Station

3X3 XYZ Type Lubrication Oil Station XYZ-250/0.4 Motor 7.5 KW Tank Area 3.3m³

Technical Parameter

Honor Award Qualification

2004.02  ISO9001: 2000 quality management system certification enterprise

2004.02  the API614 standard of the Petroleum Institute was fully applied to design and manufacture

2005.09  it was rated as one of the top 50 key enterprises in Chongqing

2006.08  won the utility model patent of plate heat exchanger

2009.05  it was awarded as a growing enterprise in Chongqing

2013.04  Invited to become a member of Chongqing Enterprise Development

2020.01  it was selected as the "Excellent Supplier of the Year-Z Best Collaboration Award" by Chongqing General Industry (Group) Co., Ltd.

Technical sharing

Thin Oil Station When the engine is not in use, the oil returns to the tank by pressure/gravity, the oil spread on the rotating crankshaft lubricates the cylinder walls and piston pin bearings are scraped off by scraper rings on the pistons, the oil also lubricates the cam bearings and camshaft drive The timing chain or gear, then the excess oil in the system will be drained back to the oil tank, reduce the friction between moving parts, reduce power loss, provide cooling effect for hot engine parts, dampen engine vibration, clean engine, help seal piston rings, not Let the high-pressure gas in the cylinder, the oil pump is the device that makes the lubricating oil enter the multiple moving parts of the engine, these parts include the crankshaft bearings and valve stems, usually located at the bottom of the crankcase, near the oil sump, and the thin oil station oil pump to filter the oil The oil is supplied by the oil filter, the oil filter is filtered forward, and then, the oil passes through the oil passage to the different moving parts of the engine, small particles may also block the oil pump and the oil passage, if the oil pump is blocked, it may seriously damage the engine and burn the engine, in order to avoid this In this case, the oil pump consists of a filter and a bypass valve.

Therefore, it is necessary to change the oil and filter regularly according to the recommendation of the thin oil station manufacturer. The purpose of the lubricant is to reduce the friction between the moving parts and the passive resistance of the fixed parts. They are produced by extracting heavy crude oil. The choice of type depends on For the application, the oil is used for the lubrication of small bearings, as a rule of thumb, the oil should be used as much as possible, because it can be cooled and filtered-more oil is applied well, it is impossible, thin oil is diesel oil, light oil , Inflammable and explosive places, pay attention to the selection. The following is the experience that LYB vertical gear pumps should pay attention to in the application of thin oil stations. When the loss of flow and pressure is serious, replacement parts should be considered. The inlet pipeline should be as simple as possible, the electrical selection should be explosion-proof, and the gears of the pump’s flow-passing parts should be copper gears.