Duplex SS WCB 304SS Vertical Gear Lube Oil Pump 1440/Min

WBZ2-125 Vertical Lube Oil Pump CB3-125 0.63Mpa 1440/Min Y112M-4-B35

Company Profile

The company is a manufacturer specializing in the manufacture of lubricating hydraulic equipment. It is a member of the Lubricating Hydraulic Professional of the China Metallurgical Rolling Association. It has produced lubricating hydraulic equipment for more than 30 years. It has strong technical force and high professional level. Centrifugal separation equipment) supporting lubrication equipment products.

Parameters:

Dimension

Do you know these maintenance tips for gear oil pumps?

As we all know, under the long-term operation of the gear oil pump, the machine will have a series of problems such as aging, shortened service life, and reduced operating power, which has become a heart disease for many users. Then how to avoid or delay it at this time? For this phenomenon, proper maintenance is very important at this time. As a professional manufacturer of Chongqing thin oil station and lubrication hydraulic equipment, Feixiong hopes to solve your doubts:

1. The gear oil pump is different from the general equipment. Its electric oil barrel pump runs at high speed, and the grease is easy to volatilize. Therefore, it needs to be added frequently to keep the lubricating energy of the bearing clean, and it is not replaced regularly.

2. The gear oil pump is mainly suitable for conveying various lubricating liquids, so it has high requirements for the storage environment and should be placed in a clean, dry and non-corrosive gas environment.

3. Periodically disassemble and inspect the gear oil pump. At the same time, special attention should be paid during the dismantling and inspection process. Every part to be disassembled must be preserved well. Special attention should also be paid to the explosion-proof surface of the explosion-proof parts so that it cannot be damaged or roughened. These include insulating gaskets and sleeves. If they are damaged, they need to be replaced with new identical parts, and substitute materials that are lower than the performance of the original materials or parts that do not conform to the specifications of the original materials cannot be used.

4. The gear oil pump also needs to be inspected for external maintenance. It is necessary to ensure that the power cord, plug, internal wiring, and switch are in good contact. It is also necessary to check whether the commutator is in good contact with the brush, whether the brush tail seat is loose, and whether the insulation resistance is normal. , whether the bearings and rotating parts are damaged, etc., effectively prevent the occurrence of short circuit and open circuit, and ensure the normal operation of the machine.

5. Special attention should be paid to the use of insulation resistance. For electric pumps that have been left unused for a long time or used in humid environments, use a 500-volt megohmmeter to measure the insulation resistance of the windings before use. If the insulation resistance between the winding and the motor casing is less than 7 megohms, the winding should be dried.

Quality Control