Magnetic with level horizontally and vertically Drilling position indicator Center gauge w/centering

• Pipe Capacity: 1" to 10", Machined from aircraft aluminum
• Replaceable leveling vials are protected by the housing and visible from 2 sides
• Rare earth magnets maintain a strong contact on pipe
• Using a Center Punch prevents the drill bit from walking on the curved surface
• Saves time and accuracy laying out crosses or multiple outlets on the same length pipe

Center gauge w/centering

Magnetic with level horizontally and vertically.

Marking of points for drilling holes in connection with drilling.

1. Clamp the pipe so that it does not rotate when the mark is made
2. Place the Center gauge in the level vertically or horizontally
3. Hit the mark with a hammer. Drill holes

This position indicator is suitable for square drilling operation. Ensure 2 holes are in the same level of surface.

With magnetism "V" type pointer, can locate the center of the hole.