I. Equipment Introduction

II. Process Flow

Raw Water - Raw Water Pressure Pump - Multi-media Filter - Activated Carbon Filter - Water Softener - Precision Filter - Primary Reverse Osmosis - pH Adjustment - Intermediate Water Tank - Secondary Reverse Osmosis - Purified Water Tank - Pure Water Pump - DI(CEDI ) - Water Point

III. Specifications 

IV. Design Features

1. The system adopts full automatic control (manual control is also available), and the automatic backwash and regeneration procedures can be set during operation.
2. All unit wiring is completed in the factory to reduce installation and debugging time.
3. Both primary and secondary reverse osmosis systems are equipped with reflux pipelines, and the RO equipment is equipped with a chemical cleaning device.
4. UPVC material is generally used for pipelines.
5. Integrated control system and instrument system for convenient operation and management.
6. RO membrane timing cleaning: The function of cleaning RO membrane upon startup and at fixed intervals extends the service life of RO membrane.
7. Water recovery rate: Through special process design, the equipment recovery rate is significantly increased to 70%.
8. The equipment has an automatic prompt function for consumable replacement, and the replacement cycle of consumables depends on changes in water quality and pressure rather than usage time, considering water quality differences in various regions.

V. Design Standards and Basis

1. Customized based on the detailed water quality report provided by the user.
2. Technical Conditions for Water Treatment Equipment
3. Standard for Reverse Osmosis Water Treatment Equipment
4. Low-voltage Switchgear and Control Gear Assemblies
5. GB6682-2008 Technical Specifications for Ultra-pure Water in Laboratories
6. GB/T11446.1-1997 Specifications for Electronic Grade Ultrapure Water

Photos: