Electric Chitherm Bf260-16 High Temp. Bell Furnace for Air Atmosphere and Electric Fuel at High Temperature

Widely used in the adhesive sintering process of zirconia ceramics, magnetic materials, electronic ceramic components and other products.

• Rated Temp.: 1500ºC
• Max Temp.: 1600ºC
• Effective Dimensions: 720mm*500mm*720mm(D*W*H)
• Heating Method: MoSi2 heating element
• Thermcouple: B-Type
• Temperature Control: 1 Point
• Temp. Set Accuracy: ±1ºC(flat temp. insulation)
• Temp. Control Mode: The Japanese Daiwa Chino Programmable Temperature Controller features PID auto-tuning functionality.
• Temp. Uniformity: ± 5ºC (empty furnace insulation test 2hours under 1500ºC)
• Maximum Heating Power: 85kW
• Insulation Power: ≤40kW
• Program Control: SCR Control Module
• Lifting Mechanism: Lead Screw Drive Elevation System
• Control Method: Phase Angle Control
• Operating Atmosphere: Air
• Exhaust System: Top-mounted exhaust stack for effluent discharge
• Protection Functions: Audible & visual alarm system for over-temperature, motor overload, and over-travel conditions
• External Dimensions: 1950*3600*3100mm(D*W*H) (without control cabinet)
• Appearance Color: Light gray

• Environmental Conditions: temperature: 0~40ºC, humidity≤ 80%RH, no corrosive gas, no strong airflow disturbance
• Atmosphere Conditions: dry, clean, oil-free compressed air, working pressure of 0.2-0.4MPa, gas consumption of 10 - 30 m3/h
• Ventilation System: non-contact access to the user pumping system, pumping capacity is greater than 30 m3/h
• Ground Requirements: horizontal, no obvious vibration, load-bearing> 500 Kg/m2
• Power Condition(TBD): capacity > 120kVA, 3-phases 5-lines, voltage 220 / 380V, frequency 50Hz. Fire line: yellow, green, red, Zero line: blue, Ground line: yellow-green
• Installation Site: 4000mm*3500mm*4000mm(D*W*H), with an installation area greater than 14m2