Display Driver ICs

3V-powered RS-232 transceiver with AutoShutdown for 1µA supply current. ±15kV ESD protection (IEC 1000-4-2). Supports 250kbps data rate. Ideal for notebook computers. Available in SSOP package.

High-speed octal bus transceiver for asynchronous bidirectional data transfer. Features 3-state outputs, wide supply range 2V to 6V, and low power consumption. Ideal for industrial control and communication systems. RoHS compliant.

The VND600SPTR-E is a dual high-side driver with 30mOhm RDS(on) and 25A current limit. Features thermal shutdown, overvoltage clamp, and proportional load current sense. Automotive AEC qualified, RoHS compliant, ideal for resistive and inductive loads.

ESD protected RS-485/RS-422 transceiver with ±15kV HBM protection. Supports up to 2.5Mbps data rate, operates from single 5V supply, and features low quiescent current of 300µA. Ideal for harsh industrial environments.

Bipolar monolithic stepper motor driver IC with half/full-step modes, 10-50V supply, and 5-1500mA current control. Features built-in protection diodes, thermal overload protection, and alarm output. Ideal for LS-TTL or microprocessor-controlled systems.

Quad channel low-side switch with 2x5A and 2x3A outputs. Features short circuit, overtemperature, and overvoltage protection. Includes separate diagnostic pins, PWM capability, and AEC qualification. Ideal for automotive and industrial solenoid, relay, and load control.

High-speed dual 4-bit binary counter with 50MHz typical frequency and 13ns propagation delay. Wide 2-6V supply range, low power consumption, and fanout of 10 LS-TTL loads. Ideal for divide-by-N counter configurations.

Toshiba TLP251F photocoupler integrates GaAlAs LED and photo IC in 8-lead DIP. Ideal for IGBT and power MOSFET gate drive, supports direct drive of lower power IGBTs up to 15A. Features 5mA input threshold, 10-35V supply, ±0.4A peak output, and 2500Vrms isolation. UL and VDE approved.

Low power RS-485/RS-422 transceiver with 300 µA quiescent current. Operates from single 5V supply. Features thermal shutdown, driver overload protection, and supports up to 64 transceivers on the bus. Ideal for industrial laser level rectifier applications.

Low power slew-rate-limited RS-485/RS-422 transceiver IC in 8-pin DIP package. Supports multiple transceiver applications with 12V max supply. Ideal for industrial communication, offering reliable data transmission and ESD protection options.

High-performance MAX 3000A CPLD with 128 macrocells, 4.5ns pin-to-pin delay, and 227.3 MHz counter frequency. Supports 3.3V core with 5.0V/3.3V/2.5V I/O compatibility. Features in-system programmability via JTAG, industrial temp range, and PCI compliance. Ideal for high-density logic applications.

ULN2003A high-voltage, high-current Darlington transistor array with 50V output and 500mA continuous collector current. Ideal for driving relays, lamps, and inductive loads. Features internal suppression diodes and 2.7kΩ input resistors for 5V TTL/CMOS logic. Reliable performance from -20°C to +85°C.

The SP334ET is a +5V programmable transceiver IC supporting RS-232 (230kbps) or RS-485 (10Mbps) modes. Features three RS-232 drivers and five receivers, or two full-duplex RS-485 transceivers with tri-state control. Ideal for industrial communication systems requiring flexible serial interface selection.

The MAX232N is a dual driver/receiver IC with integrated capacitive voltage generator for EIA-232 levels from a single 5V supply. Converts TTL/CMOS to EIA-232 and vice versa. Operates from 0°C to 70°C. Ideal for serial communication interfaces.

3.3V low power RS-485/RS-422 transceiver with ±15kV ESD protection. Supports half- and full-duplex on multipoint buses. 1/8 unit load allows up to 256 nodes. True fail-safe inputs eliminate external bias resistors. Ideal for industrial communication.

The MAX3443EASA+ is a ±60V fault-protected RS-485 transceiver supporting 10Mbps data rates and ±15kV ESD protection. True fail-safe inputs ensure logic-high output on open/short/idle lines. Hot-swap capability and 128-node bus support make it ideal for industrial networks and telecom systems.

High-speed serial link IC for fiber, coax, and twisted pair. Supports 160-400 Mbps, 8B/10B coding, low power, and BIST. Compatible with Fibre Channel, ESCON, DVB-ASI, and ATM. Pb-free options available.

High-performance EEPROM-based CPLD with 64 macrocells, 5 ns pin-to-pin delay, and 175.4 MHz counter frequency. Supports 5V in-system programming via JTAG and PCI compliance. Ideal for industrial logic control and embedded systems.

Quad channel high side solid state relay IC with 6A output per channel. Features CMOS compatible inputs, open load detection, undervoltage/overvoltage shutdown, thermal protection, and reverse battery protection. Ideal for industrial switching applications.

The HEF4050BT provides six non-inverting buffers with high current output, accepting input voltages above supply. Operates from 3V to 15V, industrial temp range -40°C to +85°C. Ideal for TTL driving, logic conversion, and high capacitive loads. ESD protected, JEDEC compliant.