Rubber Cables Flexing Test Apparatus IEC 60227.2 Figure 1 0.33m/S

Equipment overview:

The test machine is designed and manufactured according to standard IEC 60227.2 Clause 3.1 Figure 1, IEC 60245.2 Clause 3.1 Figure 1, IEC60245-1 clause 5.6.3.1 and etc. It complies with the relevant standard requirements of rubber plastic wires’ and cables’ mechanical strength flexing test. This test does not apply to flexible cables with cores of nominal cross-sectional area greater than 4mm2 and cables having more than 18 cores laid up in more than two concentric layers.

The test apparatus can meet the standard test requirements of the domestic and international standards, can be widely used. It has precision digital meter, thus, can accurately measure the smaller or larger current voltage. The change method for pulleys is simple and convenient. The test equipment adopts to chain drive mechanism, the performance is stable and the noise is rare.

Technical Characteristics:

How to installand adjustof the pulleys?

• Choose the corresponding pulleys according to the test wire/cable diameter and wire/cable core numbers.
• Installation: Loosen and remove the fixing nut, pull out the pulley, after replacing the pulley, then install the fixing nut and fasten it.
• Adjustment: Release the screws of 1, 2, A, B pulleys, then adjust pulleys’ positions, to make segments of the sample are horizontal and parallel to each others. Shown as below pictures: