RIZ30 9000RPM Freewheels 1 Directional Roller Bearing Clutch

Feature

  Types RIZ, RINZ are centrifugal lift off sprag type freewheels with the inner race rotating. Suitable for backstop, or overrunning clutch applications. Only the inner race is designed for freewheeling.
  These units are part of the Stieber modular system. They are bearing supported using series 60.. bearings, grease lubricated and fitted with ZZ seals. Units are delivered as standard lubricated with grease and ready to install in either a horizontal or vertical position. Types RIZ, RINZ are designed to be used with G series covers. The following pages give further inportant information for use of this type unit.
  If the unit is to be installed inside a housing where oil lubrication is available, please specify type RIW, RIWN. The F series covers from type GFR, GFRN are then used without shaft seals.

Dimensions and Capacities

NOTES
1) T max = 2 × T KN » Refer to Selection page 10 to 13
2) This maximum allowable torque transmission speed n max must not be exceeded when transmitting torque
3) This minimum allowable overrunning speed n imin should not be reduced under continuous operation. Possible reduction of this minimum speed on request
4) Inner race overruns Keyway to DIN 6885.1 » Refer to mounting and maintenance instructions

Pictures