Anti Dust And Brightening Agent Impregantion Additives MR0307 Red

Specification

Product Describtion

Impregnated paper in the production process commonly used additives are curing agent, penetration agent, film release agent, anti-stick agent, dust-proof agent, defoaming agent, anti-static agent; For the production of impregnated paper liquid surface with spraying section, wear-resistant paste will also be used. Additive dosage is not large, but it plays an important role in the quality and production process of veneer paper and veneer panel.

FENTENG MR307  is a cost-effective dust remover, suitable for water-based amino resin (MF&UF) and oily amino resin (phenolic resin). The use of dust remover in the production process of furniture decoration paper can not only improve the phenomenon of paper dullness, but also reduce The generation of dust protects the environmental sanitation of the workshop and the health of the personnel.

Applications

Generally, the dosage is 0.1-0.3% weight of the second stage liquid resin, and the maximum 0.5%. in order to achieve better dedusting and brightening effect. It is suggested that the minimum dosage should be determined from 0.15%.

*Note: the dedusting agent should be added before the curing agent, and then the curing time should be tested.

It may condense or precipitate below 20 ℃.

PHYSICAL AND CHEMICAL PROPERTIES

Molecular weight: not applicable

Boiling point (ºC): about 90-100

Melting point (ºC):about 0

Specific gravity (water=1):0.95-1.15

Solubility in water(g/L0: Soluble

pH (as supplied):6.5-7.5

pH (1% solution): 7

Vapor pressure (kPa): None

Volatile component(%volume) :N/A

Evaporation rate: N/A

Relative vapor density (air＝1): N/A

Flash point(ºC): Not applicable

Lower explosive limit%: Not applicable

Upper explosive limit%: Not applicable

Heat of combustion(ºC): N/A

Decomposition temperature(ºC): N/A

State: liquid Viscidity: N/A

FQA:

Q: How can I place order?

A: You can contact us by email about your order details, or place order online.

Q: How can I pay for you?

A: After you confirm our PI, we will request you to pay. L/C or T/T is the most usual ways we are using.

Q: how do you control quality?

A:We will make samples before mass production and start mass production after sample approval. 100% inspection during production and random inspection before packaging.

Q: how to contact us?

A:Click "contact supplier" and send us the product information you are interested in. You will get a reply within 24 hours.