Emulsified Asphalt Wet Wheel Abrasion Tester YT-1

Emulsified Asphalt Wet Wheel Abrasion Tester

The amount of asphalt in emulsified asphalt slurry mixture is designed in the ratio. Important parameters, too little asphalt, slurry sealing layer will be loose, too much asphalt, the road will be wrapped, and also waste asphalt material. Wet-wheel abrasion tester can be used to determine the sealing mixture of emulsified asphalt slurry with load wheel test. Optimum asphalt dosage. This test is used to determine the slurry mixture. Small amount of asphalt, but also used to test the slurry mixture after forming wear properties.

The wet-wheel wear test is to place the molded slurry mixture specimen in water according to the specified molding method, and grind the head with the wet-wheel wear tester for 5min to measure the wear loss. The wet-wheel wear loss is expressed as g/㎡.

MACHINE:Emulsified asphalt wet wheel abrasion tester

MODEL:YT-1

Technical Parameters

 Wearing disc size: disc diameter φ330±1㎜, depth 50±1㎜
 Template: outer diameter ￠300mm, inner diameter ￠280mm
 Weight of wear head: 2.27±0.001kg
 Rubber tube: length 127㎜, hardness 60HA
 Grinding head speed: revolution 61 rpm, rotation 140 rpm
 Digital time counter: 0-99 hours and 99 minutes can be set

Configuration List

Host 1
 1 sample plate
 One plastic template Φ280
 3 rubber tubes
 One hexagonal wrench
 Scraper 1 piece