OEM ODM Replaceable Figure 607 Hammer Union Vee Lip Type Seal Ring

Other types

For an OEM drawing or replacement enquiry for a Figure 607 vee lip ring, provide the approved seal and mating groove drawings. Include revision, dimensional tolerances and equipment identification. A sample can support profile review, while the drawing defines the required replacement configuration.

Confirm the Figure 607 lip profile and orientation rather than assuming compatibility with the other union figures listed here. Nominal size alone does not establish an interchangeable replacement.
Specify the exact NBR, FKM or HNBR compound, hardness tolerance and service conditions. Brass or stainless steel backup construction requires a matching drawing. Sour-gas service needs compound-specific qualification; PTFE and PU alternatives require separate grade and geometry review.

OEM and replacement enquiry requirements:

Drawing revision: Provide seal and groove drawings with dimensional tolerances and the required revision.
Sample review: Identify whether the sample is new or used and record any deformation before dimensional comparison.
Material specification: Include compound designation, hardness tolerance, service fluids and temperature and pressure cycles.
Acceptance requirements: Agree dimensional checks and any required compound or assembly tests with the purchase specification.
Send the drawing, equipment identification and order quantity to review the Figure 607 replacement ring.

What we Shanghai Qinuo Industry Provide:

Rubber O rings

• Rubber O rings -As568 series rubber o rings/JB standard rubber o rings.
• Encapsulated rubber o rings- silicone/ FKM rubber o rings
• PTFE coating rubber o rings-kinds of color rubber o rings

Hammer Union seals- 1" 1.5" 2" 3" 4" 6" 7"

• Rubber hammer union seals-Buna/FKM/HNBR rubber type
• Rubber w/brass or stainless steel back up types

Swab cups

• V types 4" 5.5" ect.
• TA type
• MV type
• NUF type
• TUF type

Rubber seal kits- custom packing or lable is available

• #10 setting tool - With burst disk
• #20 setting tool - With burst disk
• AP Compact Setting Tool Kit
• Grease Tubes Seal Kit
• 3 1/2” Shorty Kits
• 3 - 1/8" Weight Bar Kit
• #10 Baker Firing Head Kit
• #20 Firing Head Kit
• #20 BP3.SEC kits
• #10 BP3.SEC kits
• T-BRT redress kit
• T-1 Set
• GC Stripper Head Redress Kits

Wireline Component Parts:

1) Pressure Relief Disc, ZD Plated (application:rupture(bleeder) Disc)

2) Rubber Push Pin -black

3) Nylon Push Pin -natural

4) Retainer Nut, Steel, ZD Plated (Flat, beveled also available) (application: retainer nut)

5) Threaded Steel Plug, w/ Lathe Cut (application:5" port plug)

6) Threaded Brass Plug (application: setting tool plug )

Rubber Packer Elements:

Rubber Oil Savers:

FAQ: